|
Post by bookcliffs on May 20, 2024 18:05:15 GMT -5
I'd like to replace the synthetic stock on my ML10-2. Anyone have a used one for sale? Or suggestion? Thx
|
|
|
Post by GMB54-120 on May 21, 2024 15:37:16 GMT -5
What screw spacing? If its a 4.27" your options are a little more limited. Boyds has some for both spacings. If its 4.4" and you are looking for more of a bench stock, EABCO has a laminate thumbhole already pillared for $250.
|
|
|
Post by jims on May 23, 2024 6:24:55 GMT -5
Richard's Microfit Stocks sell a variety of wood Sav stocks that will handle both spacings but they take a fair amount of sanding etc. Walnut, maple and laminates.
|
|
|
Post by Richard on May 23, 2024 15:18:55 GMT -5
I have dealt with both of the above stocks and would definitely go with a Boyd's pre-finished stock. The Richard's microfit are a LOT of work.
|
|
|
Post by dannoboone on May 24, 2024 12:24:55 GMT -5
I have dealt with both of the above stocks and would definitely go with a Boyd's pre-finished stock. The Richard's microfit are a LOT of work. Amen and Amen! I suckered for one of Richard's macrofits....never again! I have several Boyd's and there is very little, seldom anything to be done to make them fit. Sometimes a dremel is needed to get out some very small "burrs". But then, I had to get fancy and pillar & bed most of them.
|
|