|
Post by oldranger on Feb 9, 2024 21:38:20 GMT -5
Got some Pittman bullets and great advice from Kyle Pittman on how to shoot them. I sized 3 sets of bullets. The first set was the largest that would start down the barrel after many very small adjustments in the sizer. The next set was slightly smaller and the next slightly smaller than that. The first set all hit the same elevation within a 0.5 inch but strung 2.2 inches horrizontally. The second set all hit the same elevation within 0.25 inches but strung 1.1 inches horrizontally. The third group,the smallest bullets, all touched with a slight vertical stringing if you could even call that stringing. I shot two bullets to foul the barrel prior to the 3 sets. So, does increased fouling explain the group size improvement as the sets progressed ? Or is bullet sizing the answer ? Horizontal stringing is often attributed to barrel / forearm fit. This is a Scout and the fit is not uniform. Thanks, Oldranger
|
|
|
Post by SURESHOT on Feb 10, 2024 11:11:35 GMT -5
In sure that the breech plug is in tight, I had one of a friends to string and found the breech plug was not tight,, cut holes after re installing with a good snug!!
|
|
|
Post by Richard on Feb 13, 2024 15:15:29 GMT -5
You might try getting the answer by shooting three groups each sized differently on a "clean" barrel and see the results? If the third looser fit on a clean barrel produces good results?...then you got your answer. If not, do the test again on a fouled barrel and see the results? Too many new shooters are unwilling to do their own testing. It is with this testing that you find out what does and does not work; plus, the practice is good!
|
|