|
|
Post by strongbox on Sept 16, 2017 16:22:40 GMT -5
Just received my Apex 45 conversion from Jeff---Could use some help on proper sized socket to remove plug and where purchased. It is possible that I have the riight size but walls of socket are too thick.
Thanks in advance
|
|
|
|
Post by jimmykip on Sept 16, 2017 16:30:11 GMT -5
11mm on mine I seem to remember.
|
|
|
|
Post by aldeerhunter on Sept 16, 2017 16:34:58 GMT -5
It is possible that the walls of your socket is too thick. I use an 11mm wrench and extension for my 700ml from my craftsmans ratchet set. You will need a thin wall socket.
|
|
|
|
Post by Hank on Sept 16, 2017 17:23:25 GMT -5
7/16 socket , 1/4 inch drive, craftsman should work.
|
|
|
|
Post by dennis on Sept 16, 2017 17:24:36 GMT -5
I am able to use both 7/16 and 11mm thin wall 1/4 drive.
|
|
|
|
Post by 10gaauto on Sept 16, 2017 19:01:29 GMT -5
I am able to use both 7/16 and 11mm thin wall 1/4 drive. X2 for me!
I have made up separate dedicated socket tools for plug removal for each gun. I keep them in the hard cases with the gun or in the "kit box" dedicated for each. 10
|
|
|
|
Post by dennis on Sept 16, 2017 19:12:25 GMT -5
I am able to use both 7/16 and 11mm thin wall 1/4 drive. X2 for me!
I have made up separate dedicated socket tools for plug removal for each gun. I keep them in the hard cases with the gun or in the "kit box" dedicated for each. 10
I need to separate mine too. I used to but now its all getting mixed up. I'll get to that soon., my wife is having health issues again and that is what is the most important . Everything else is going to have to wait. |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 16, 2017 19:40:17 GMT -5
Definitely 1/4" drive. The socket outside diameter must measure less than .695"
|
|
