Post by aldeerhunter on Aug 11, 2017 23:34:27 GMT -5
My gun, Dolemite, has an approximately 3 inch muzzle brake. I tried to find a funnel but could not find anyone willing to sell me one. So, I broke down and decided to build one myself.
I ordered stainless steel funnels from Amazon, and then went to AutoZone and purchased an 11 inch brake line. It cost about 12 bucks. It had two brass nuts on it so I tossed them in the drawer. This is plenty enough tubing to make two funnels.
I used JB Weld to connect the tubing to the funnel and used a Dremel to smooth off the lip of the tube on the inside of the funnel. I have yet to purchase a bench grinder at our new home although we have been here about ten years. I will do a better job of smoothing out the end when I get one. I just used the Dremel to smooth out the burs on the end. I also cut the tube with the Dremel since I did not have anything else handy.
Nothing fancy but it serves my purpose well. Here is the Amazon link for the funnels I purchased:
I ordered stainless steel funnels from Amazon, and then went to AutoZone and purchased an 11 inch brake line. It cost about 12 bucks. It had two brass nuts on it so I tossed them in the drawer. This is plenty enough tubing to make two funnels.
I used JB Weld to connect the tubing to the funnel and used a Dremel to smooth off the lip of the tube on the inside of the funnel. I have yet to purchase a bench grinder at our new home although we have been here about ten years. I will do a better job of smoothing out the end when I get one. I just used the Dremel to smooth out the burs on the end. I also cut the tube with the Dremel since I did not have anything else handy.
Nothing fancy but it serves my purpose well. Here is the Amazon link for the funnels I purchased:
Attachments:
