bfox
New Member
Posts: 10
|
Post by bfox on Jan 26, 2021 19:47:08 GMT -5
After managing to get a HIS primer module stuck behind the extractor, I decided to try and grind the angle face off the extractor by approximately .035" which would then lessen the amount it would eject. However I took too much off and now you have to pick the modules out (which is fine for the range but not while hunting with gloves on). Does anyone know where I can order another one?
|
|
|
Post by blackpowder72 on Jan 26, 2021 19:52:42 GMT -5
I did the same thing. There is a round piece in front of the extractor that pushes it out when the gun is open . I wrapped mine with electrical tape until it pushed it out far enough. Been that way for 2 years.
|
|
bfox
New Member
Posts: 10
|
Post by bfox on Jan 26, 2021 20:13:31 GMT -5
Ok thanks!
|
|
|
Post by dennis on Jan 26, 2021 20:33:23 GMT -5
After managing to get a HIS primer module stuck behind the extractor, I decided to try and grind the angle face off the extractor by approximately .035" which would then lessen the amount it would eject. However I took too much off and now you have to pick the modules out (which is fine for the range but not while hunting with gloves on). Does anyone know where I can order another one? I just took a (blued/black) one out of a Scout barrel I am having Hank convert using DI. My Scout is not a V2 so not sure if the same. Where do you live? PM me.
|
|
|
Post by buckeye68 on Jan 26, 2021 23:30:36 GMT -5
A little dab of JB would do the trick also
|
|