|
Post by elkman1310 on May 19, 2019 21:26:43 GMT -5
I put two new Mullerworks barrels on and chambered then both for a 6mm Dasher funny how every barrel is different one loves 103gr Vapor Trail bullets the other 107gr Sierra looks the best at 1,000 yards. Today I used my one Dasher to compete in our 1000 yard match. I used the one that likes the 103gr Vapor Trails using 32.2grs of H4895 and a br4 primer this gun shot a 5.7 inch 10 shot group 9 shots went into 3.181 inch but like Richard likes to say there is always one democrat that has a mind of its own and it goes out of the group mine was #7 went low for some unknown reason could have been a little less BC for that bullet even though I check them every way possible you don't really know till you shoot them
So bottom line I am very pleased with the MullerWorks barrels they clean up super easy so if your in the market for a new barrel I don't think you can go wrong with one of Dan Mullers barrels.
|
|
|
Post by jims on May 20, 2019 6:45:41 GMT -5
nice shooting
|
|
|
Post by dennis on May 20, 2019 13:39:40 GMT -5
Glad your barrels are working out for you. Fine shooting.
|
|
|
Post by jimbob on May 20, 2019 14:31:47 GMT -5
How many FPS are you running those 103s
|
|
|
Post by elkman1310 on May 22, 2019 18:21:58 GMT -5
Surprisingly 3045fps . Normally I try to stay right around 2960fps but the gun won't shoot till I hit the high end node. More velocity is better in the wind anyway.
|
|
|
Post by jimbob on May 22, 2019 20:20:40 GMT -5
Ok thanks I’m shooting a 6mm Bra with 30.6 of 4895 and 105s I’m getting 2970 I knew you were pushing them pretty good with that amount of powder
|
|
|
Post by elkman1310 on May 22, 2019 22:21:24 GMT -5
A few guys are shooting the 6mm BRA at our club. These Muller barrels are the fastest barrels I have had. I had a Krieger I struggled with the get to 2960 with and powder combo.
|
|