|
Post by linebaugh on Sept 19, 2016 14:28:20 GMT -5
Does anybody know and want to comment on either an economical gunsmith for conversion of a 700 bolt to PPC or give me the cliff notes on how to do it myself? I am not a Remmy guy but am tired of the same old thing and looking for a change of actions. Thanks.
|
|
|
Post by Hank on Sept 19, 2016 16:25:52 GMT -5
Its pretty easy really. You need to remove the factory extractor, machine away the unwanted metal. solder in a new ring and re-machine to correct dimensions and install a Sako extractor... You are now ready to rock and roll.
I do all of the above for $150.00
|
|
|
Post by Richard on Sept 28, 2016 20:36:01 GMT -5
That is a deal! I have never soldered in the ring (but that would seem like the easy part) but I have done about 3 Sako extractors and got nervous every one I did! If you mill the slot "not deep enough?" then you can always go deeper but, if you go too deep? You are up the creek W/O a paddle. OR you need a good TIG welder Of curse, the more you do the better you get at it.
|
|